Go to documentation repository

Page tree

Documentation for Intellect 4.10.4. Documentation for other versions of Intellect is available too.

Previous page General information on camera arming and disarming  Camera arming Next page


Skip to end of metadata
Go to start of metadata

Note

This section describes the default parameters of the color indication of the video surveillance window border. They can be changed during the system configuration - see Configuring Viewing tile frame color.

The colour of the video surveillance window border indicates the current camera status.

Colour of the video surveillance window border

Camera status

Green

Camera disarmed

Yellow

Camera armed

Red

Camera is armed, alarm event occurred on camera.

OR

Camera is disarmed, but one ore more auxiliary zones are configured as alarmed and alarm is detected on them – see also Indication of detection tool status.

The colour of the camera number indicator border in the surveillance window indicates the current status of the video recording from the camera.

Colour of the camera number border

Camera status

Green

No video recording, camera is disarmed

Yellow

No video recording, camera is armed

Red

Video recording

The combinations of the video surveillance window border colour and the colour of the camera number border are described in the following table.

Colour of the window border

Colour of the camera number border

Camera status

Yellow

Yellow

Camera is armed, no video recording is performed

Red

Red

Alarm event occurred on the camera or alarmed detection zone, video recording is started by an alarm or the recording, started by Operator's command before the event, goes on,

Green

Red

Camera is disarmed, but there is recording by Operator's command or post-alarm recording.

Yellow

Red

Camera is armed, recording by Operator's command or post-alarm recording is done.

Green

Green

Camera is disarmed, no video recording is performed

Red

Yellow

Alarm event occurred on camera or alarmed detection zone, but no video recording by alarm is done.

Note.

If the auxiliary camera detector zone has been armed or disarmed, the border around the video surveillance window retains its colour, but after an alarm event in the auxiliary zone the window border becomes red. So, there is no indication of auxiliary detector zone arming and disarming for the camera by the frame of the Video Surveillance Window. See also Indication of detection tool status.

The icon of video absence  appears under the icon of "video camera number" only when there is no video signal. It can be in two cases: video camera is not connected or there is camera restart.

Note.

The last video frame or blue screen (depending on the video capture card) is displayed in the Video surveillance window if there is no video signal.

The icon of selected disk absence  appears over the icon of "video camera number" only when disk for archive saving is not selected.

When incorrect camera type is given, the icon of disconnect with the camera  appears over the icon of "video camera number" and the frame of video surveillance window becomes black.